Qlogic SANbox 5600 Series

B – Command Line Interface
Reset Command
B-52 59096-02 C
S
Enter the Show Setup Radius command to display RADIUS configuration
values.
Enter the Show Setup Services command to display switch service
configuration values.
Table B-14. RADIUS Configuration Defaults
Parameter Default
DeviceAuthOrder Local
UserAuthOrder Local
TotalServers 1
DeviceAuthServer False
UserAuthServer False
AccountingServer False
ServerIPAddress 10.0.0.1
ServerUDPPort 1812
Timeout 2 seconds
Retries 0
SignPackets False
Table B-15. Services Configuration Defaults
Parameter Default
TelnetEnabled True
SSHEnabled False
GUIMgmtEnabled True
SSLMgmtEnabled False
EmbeddedGUIEnabled True
SNMPEnabled True
NTPEnabled False
CIMEnabled True
FTPEnabled True.
MgmtServerEnabled False