B – Command Line Interface
Zoning Command
B-140 59096-02 C
S
save
Saves changes made during the current Zoning Edit session. The system informs
you that the zone set must be activated to implement any changes. This does not
apply if you entered the Zoning Clear command during the Zoning Edit session.
Examples The following is an example of the Zoning Edit command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #>
.
.
SANbox (admin-zoning) #> zoning cancel
Zoning edit mode will be canceled. Please confirm (y/n): [n] y
SANbox (admin) #> admin end
The following is an example of the Zoning Limits command:
SANbox #> zoning limits
Zoning Attribute Maximum Current [Zoning Name]
---------------- ------- ------- -------------
MaxZoneSets 256 6
MaxZones 2000 17
MaxAliases 2500 1
MaxTotalMembers 10000 166f
MaxZonesInZoneSets 2000 19
MaxMembersPerZone 2000
10 D_1_JBOD_1
23 D_1_Photons
9 D_2_JBOD1
16 D_2_NewJBOD_2
5 E1JBOD1
5 E2JBOD2
3 LinkResetZone
3 LinkResetZone2
8 NewJBOD1
8 NewJBOD2
24 Q_1Photon1
8 Q_1_NewJBOD1
13 Q_1_Photon_1
21 Q_2_NewJBOD2
3 ZoneAlias
3 ZoneDomainPort
4 ZoneFCAddr
MaxMembersPerAlias 2000
2 AliasInAZone
To Next Page
Loading...
Need help?
General
