4 ā Installation
Installing a Switch
4-24 59096-02 C
S
ī Serial ā Windows: Open the HyperTerminal application on a Windows
platform.
a. Choose the Start button, select Programs, Accessories,
HyperTerminal, and HyperTerminal.
b. Select the connection you created earlier and choose the OK
button.
ī Serial ā Linux: Open a command window and enter the following
command:
minicom
ī Serial ā Solaris: Open a command window and enter the following
command:
tip sanbox2
2. Open an admin session and enter the Set Setup System command. Enter
the values you want for switch IP address (Eth0NetworkAddress) and the
network mask (Eth0NetworkMask). Refer to āSet Setup Commandā on
page B-82 for more information about this command.
SANbox #> admin start
SANbox (admin) #> set setup system
3. Open a Config Edit session and use the Set Config command to modify the
switch configuration. Refer to the āConfig Commandā on page B-17 and āSet
Config Commandā on page B-64 for more information.
To Next Page
Loading...
