Quantum QXS G2 Series User Manual

96 QXS G2 Hardware Installation and Maintenance Guide
1
Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2
Verify the appropriate COM port for use with the CLI.
5 In the terminal emulator, connect to controller A.
6 Press Enter to display the CLI prompt (#).
The CLI displays the system version, Management Controller version, and login prompt.
a At the login prompt, enter the default user
manage.
b Enter the default password
!manage.
If the default user or password—or both—have been changed for security reasons, enter the
secure login credentials instead of the defaults shown above.
7 At the prompt, enter the following CLI command to set the values you obtained in step 1 for each
network port, first for controller A, and then for controller B:
set network-parameters ip address netmask netmask gateway gateway controller
a|b
where:
• address is the IP address of the controller
• netmask is the subnet mask
• gateway is the IP address of the subnet router
• a|b specifies the controller whose network parameters you are setting
For example:
#
set network-parameters ip 192.168.0.10 netmask 255.255.255.0 gateway
192.168.0.1 controller a
# set network-parameters ip 192.168.0.11 netmask 255.255.255.0 gateway
192.168.0.1 controller b
Ta b l e 1 0 Terminal Emulator Display Settings
Parameter Value
Terminal emulation mode VT-100 or ANSI (for color support)
Front Terminal
Translations None
Columns 80
Ta b l e 1 1 Terminal Emulator Connection Settings
Parameter Value
Connector
COM3 (for example)
1,2
Baud rate 115,200
Data bits 8
Parity None
Stop bits 1
Flow control None

Quantum QXS G2 Series Specifications

General

Brand	Quantum
Model	QXS G2 Series
Category	Storage
Language	English