Existing Objects
1. Press PGM to put scanner in Program Mode.
2. Press S, T, W or X to scroll to the object
you want to change.
3. Press EDIT softkey.
4. Press CURR softkey to edit the current object.
5. Scroll down to
Scan Lists:
6. Press X to scroll through the Scan Lists.
7. Press SEL to select On or Off for the desired
scan list item. The asterisk (*) next to the Scan
List number indicates that the object is a
member of that Scan List.
8. Press Save softkey to save change.
Naming Scan Lists
1. Press PGM to put scanner in Program Mode.
2. Press GLOB softkey.
3. Press S or T to scroll to Scan Lists:.
4. Press SEL.
5. Press X to edit the settings for the selected
Scan List.
6. Press S or T to scroll to Tag:, then press X.
7. Use the number keys to enter a name. See
“Appendix C: Text Entry and QuickText”Appendix C: Text Entry and QuickText” on page
125 for information on entering text.
8. Press Done softkey when finished.
9. Press Save softkey to save changes to the
Global menu.
Enabling or Disabling Scan Lists
While Scanning
Scan List 1-10
Press the number keys that corresponds with the
Scan List you want to select.
For example, pressing 4 while scanning will
toggle the state of Scan List 04 from enabled to
disabled, or vice versa if the Scan List is already
disabled.
Scan List 11-20
Press FUNC, then press a number key, i.e., press
FUNC 3 to toggle the status of Scan List 13.
Note: If you enable a Scan List that has no
assigned objects, the number for that Scan
List will flash in the display while the scanner is
scanning.
From Global Settings Menu
1. Press PGM to enter Program Mode.
2. Press GLOB softkey.
3. Press S or T to scroll to Scan Lists: and
press SEL.
4. Press S or T to scroll to the Scan List you
wish to change then press SEL.
5. Press X to scroll to Enabled: and press
W or X to select On or Off.
The asterisk (*) indicates Scan List enabled.
6. Press the Save softkey to save settings.
7. Press
Save softkey again to confirm global
changes and exit GLOB menu.
To Next Page
Loading...
