To create a new SRVC object
1. Press
PGM for Program Mode.
2. Press NEW softkey, then press SRCH softkey to
view the available Search types.
3. Press the SRVC softkey.
4. Press T to scroll to the Srvc: field.
5. Press W or X to select the type of search you
want to define. Service types include Public
Safety, Aircraft, Amateur, CB, Marine, FRS/
GMRS/MURS/DOT and Railroad.
6. Press Save softkey to store your SRVC search
as an object.
To activate SRVC search:
1. Press
MAN during scanning to enter Manual
Mode.
2. Press S or T to scroll through the objects to
SRVC.
3. Press the SRCH softkey to activate the SRVC
search. SRVC search stops when an active
frequency is found.
frequency lockout list
4. To resume searching, press S.
Signal Stalker II Object (STLK)
A Signal Stalker Object (STLK) stores the parameters
necessary for the radio to rapidly sweep a range
of frequencies for strong signals from nearby
transmitters. A STLK object can be used for
standalone operation—the radio just sweeps and
stops when activity is detected, or for stalking that
is performed while the radio is scanning. During
scanning, the radio will check for activity on all the
enabled Scannable Objects: TGRP objects, CONV
objects, LMIT objects and STLK objects.
Essential Parameters
By default, a newly created STLK object is
ready to go without any changes. In its default
configuration, the STLK object will sweep through
all of the important land mobile radio bands
and look for strong signal activity from nearby
transmitters. You may wish to include or exclude
some bands in your sweeps in order to check other
frequency ranges or to limit the amount of time
the scanner spends sweeping frequency ranges
where local transmitter activity is less likely. See
“Appendix B: Detailed Menu Reference: STLK Menu” on
page 122 for detailed menu information.
To create a new STLK object:
1. Press
PGM to place your scanner into
Program Mode.
2. Press
NEW softkey, then press SRCH softkey to
view the available Search types.
3. Press
STLK softkey.
4. Scroll down to Type: and press X if you want
to change between
All Bands and Public
Safety.
Refer to “Dedicated Signal Stalker II” on page 64 or
“Appendix A: Search Bands” on page 100 for sub-
band frequency information.
To Next Page
Loading...
