4. Press S, T to scroll to the TSYS item
and press the SEL key to edit the TSYS
parameters.
5. Press W or X to scroll to Multi-Site.
6. Press W or X to select Off, Stat or Roam.
Off:
the scanner will find the first usable
control channel in the control channel list and
use it until it is no longer usable.
Stat (Stationary): the scanner will track the
system using any control channel in the list
that is usable.
Roam: the scanner will attempt to locate
and use the best possible control channel
and ignore others, until the control channel
is no longer usable, then it will locate a new
“best control channel” to use. The scanner
will always attempt to lock on to control
channels where the decoding quality is
greater than the Threshold Hi setting, and
will search for new control channels when
the decoding quality of a control channel
drops below Threshold Lo setting. If no new
control channels are available that meet the
Threshold Hi criteria, the scanner will seek
the best control channel to use, and continue
checking periodically for a new control
channel that meets the Threshold Hi criteria.
7. Press SAVE softkey to save your changes to
the TSYS parameters.
8. Press SAVE softkey again to use the scanner.
You should experiment with the different Multi-
site modes and the threshold settings to find a
combination that works best for your location.
Notes:
• Multi-site functionality is not available in
EDACS or LTR trunking.
• Threshold settings are only available when
Multi-Site Roam is selected.
• It may be necessary to change the values
used for Threshold Hi and Threshold Low in
the TSYS object to optimize Multi-site Roam
performance.
LTR Home Repeater AutoMove
LTR Home Repeater AutoMove (AutoMove HRs)
takes the guesswork out of programming LTR
trunking systems when the home repeater order
is not known.
By default, AutoMove HRs is turned off and is
controlled in the individual TSYS objects. When
AutoMove HRs is turned on, you may enter the
LTR system frequencies in any order. Your scanner
will automatically move the frequencies to the
proper home repeater slots as transmissions are
received on the system.
To enable LTR Home Repeater AutoMove:
1. Access the menu for the desired TSYS.
2. Press
T to scroll to AutoMove HRs.
3. Press W or X to toggle on or off for the
selected LTR TSYS.
4. Press Save softkey to save your changes.
To Next Page
Loading...
