TGRP
Parameter
Options Description
LED Mode Solid or
Flash
Controls whether the Alert
LED flashes or remains on solid
when the Alert LED is used.
LED Color 0-7 Sets LED color to 0-7 as
defined in the GLOB menu.
By default, 0=LED Off, 1=Red,
2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
Latch LED On or Off Normally the Alert LED is active
only while the object is receiv-
ing a transmission. When Latch
is on, the Alert LED will remain
lit after the transmission is com-
plete, unless overridden by a
subsequent object that is also
using the Alert LED.
Backlight On, Off or
Flash
Controls whether the backlight
should be on, off or flashing
while the object is active.
Alarm None,
Chirp,
Hi-Lo,
Alert,
Ring,
2-Chirp,
Fast
Hi-Lo,
DTMF#
Sets the Audible Alarm for the
TGRP object. When an Audible
Alarm is selected, the selected
alarm will play at the beginning
of each transmission on the
TGRP object, or anytime the
scanner stops for activity on the
TGRP object while scanning.
Fav Yes or No When On, the TGRP object is a
member of the Favorites Scan
List.
Skywarn Yes or No When On, the CONV object is
a member of the Skywarn Scan
List.
EXPERT BELOW
Delay On or Off Controls whether a Delay is
used to wait for reply traffic af-
ter a transmission on the TGRP.
TGRP
Parameter
Options Description
Delay Time 1-250 x
100 ms
Sets the amount of time (in 100
millisecond intervals) for the
wait for reply delay if Delay is
On, e.g., 20=2 seconds.
AudioBoost On or Off Applies a 6 dB boost to audio
levels when the object is active.
Hit Count Numeric
value
Increments each time a trans-
mission is received on the
TGRP object. Global “Hit
Counts” must be set to ON.
Press the
Dflt softkey to reset
to 0.
TSYS Menu
The TSYS menu is used when creating new
Trunking System objects, or editing existing
Trunking System objects.
TSYS
Parameter
Options Description
Type MOT
800/900,
MOT
VHF/UHF,
P25
MANUAL,
P25
AUTO,
EDACS
STD,
EDACS
NAROW,
LTR
Sets the trunking system type.
Choose MOT 800/900 if the
system is a Motorola 800 or 900
MHz analog or digital trunked
radio system that uses the 3600
baud control channel. Use
P25 AUTO for most Project
25 systems that send channel
table information over the sys-
tem control channel. Use P25
MANUAL if it is necessary to
manually set the channel table
information or if you wish to use
the default 800 MHz table data.
Use EDACS STD for most 800
MHz EDACS systems using the
9600 BPS EDACS control chan-
nel. Use EDACS NAROW for
most 900 MHz and some VHF/
UHF EDACS systems using the
4800 BPS EDACS control chan-
nel. Use LTR for Logic Trunked
Radio (LTR) systems.
To Next Page
Loading...
