STLK Menu
The STLK menu is used when creating new Signal
Stalker II objects, or editing existing Signal Stalker
II objects.
STLK
Parameters
Options Description
Scan Lists On or Off
for Scan
Lists 1-22
Sets membership in Scan Lists.
Use _` keys to scroll through
Scan Lists. Use SEL key to tog-
gle Scan List membership. A
“*” next to the Scan List num-
ber indicates that the object is
mapped to that Scan List.
Type All Bands
or Pub
Safety
Use _` to select All Bands or
Public Safety. All Bands covers
the entire frequency range of
the scanner. Pub Safety covers
frequency ranges commonly
used for public safety commu-
nications.
Sub-bands
_`, SEL
Sub bands are available when
using STLK in All Bands or Pub-
lic Safety mode.
See Appendix A on page 100 for
Search Band Group frequencies.
Tag Alpha-
numeric
text
The alphanumeric display
name for the STLK object. Use
the standard text entry method
or QTXT to name the object.
L/Out On or Off Permanent lockout for the
STLK search. Also accessed by
pressing FUNC L/OUT while
the scanner is stopped on the
STLK object.
LED Mode Solid or
Flash
Controls whether the Alert
LED flashes or remains on solid
when the Alert LED is used.
LED Color 0-7 Sets LED color to 0-7 as de-
fined in the GLOB menu. By
default, 0=LED Off, 1=Red,
2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
STLK
Parameters
Options Description
Latch LED On or Off Normally the Alert LED is active
only while the object is receiv-
ing a transmission. When Latch
is on, the Alert LED will remain
lit after the transmission is com-
plete, unless overridden by a
subsequent object that is also
using the Alert LED.
Backlight On, Off
or Flash
Controls whether the backlight
should be on, off or flashing
while the object is active.
Alarm None,
Chirp,
Hi-Lo,
Alert,
Ring,
2-Chirp,
Fast
Hi-Lo,
DTMF#
Sets the Audible Alarm for the
STLK object. When an Audible
Alarm is selected, the selected
alarm will play anytime the
scanner stops for activity on the
STLK object while scanning.
Fav
Yes or No
When On, the STLK object is a
member of the Favorites Scan
List.
EXPERT BELOW
Atten On or Off When on, applies 20 dB of at-
tenuation to all hits received on
the STLK search. Useful in areas
where interference from nearby
strong signals is present.
Delay On or Off Controls whether a Delay is
used to wait for reply traffic af-
ter a transmission on the STLK
search.
Delay Time 1-250 x
100ms
Sets the amount of time (in 100
millisecond intervals) for the
wait for reply delay if Delay is
On, e.g., 20=2 seconds.
To Next Page
Loading...
