SRVC
Parameter
Options Description
L/Out On or Off Permanent lockout for the
SRVC object. Also accessed by
pressing FUNC L/OUT while
the scanner is stopped on the
SRVC object.
LED Mode Solid or
Flash
Controls whether the Alert
LED flashes or remains on solid
when the Alert LED is used.
LED Color 0-7 Sets LED color to 0-7 as de-
fined in the GLOB menu. By
default, 0=LED Off, 1=Red,
2=Yellow, 3=Green, 4=Cyan,
5=Blue, 6=Magenta, 7=White.
Latch LED On or Off Normally the Alert LED is ac-
tive only while the object is
receiving a transmission. When
Latch is on, the Alert LED will
remain lit after the transmission
is complete, unless overridden
by a subsequent object that is
also using the Alert LED.
Backlight On, Off or
Flash
Controls whether the backlight
should be on, off or flashing
while the object is active.
Alarm None,
Chirp,
Hi-Lo,
Alert,
Ring,
2-Chirp,
Fast
Hi-Lo,
DTMF#
Sets the Audible Alarm for
the SRVC object. When an
Audible Alarm is selected,
the selected alarm will play
anytime the scanner stops for
activity on the SRVC object
while scanning.
Fav Yes or No When On, the SRVC object
is a member of the Favorites
Scan List.
SRVC
Parameter
Options Description
EXPERT BELOW
Modulation Auto, AM,
FM, NFM
Modulation setting for the
SRVC search. In most cases
Auto will work fine. Use AM to
override and force AM modu-
lation, FM to force FM modula-
tion, NFM to force narrow FM
modulation.
Atten On or Off When on, applies 20 dB of at-
tenuation to all hits received
on the SRVC search. Useful
in areas where interference
from nearby strong signals is
present.
Delay On or Off Controls whether a Delay is
used to wait for reply traffic
after a transmission on the
SRVC search.
Delay Time 1-250 x
100ms
Sets the amount of time (in 100
millisecond intervals) for the
wait for reply delay if Delay is
On, e.g., 20=2 seconds.
Zeromatic On or Off When on, enhances the
scanner’s ability to lock on to
the actual center frequency of
a search hit instead of an adja-
cent frequency.
Search Dir Up or
Down
Sets search direction used
when SRVC object is active.
Hit Count Numeric
value
Increments each time a trans-
mission is received on the
SRVC object. Global “Hit
Counts” must be set to ON.
Press the
Dflt softkey to
reset to 0.
To Next Page
Loading...
