Power-On Configuration Key Sequences
Power-on keypress sequences are used as
shortcuts to configuration items, like attenuator
settings, backlight settings and memory
information. Power-on key sequences are also
used to place your scanner into firmware upgrade
mode for CPU and DSP firmware upgrades.
The following table lists the power-on key
sequences available in the PRO-106. Unless
otherwise specified, each sequence is invoked by
pressing and releasing each key in sequence, one
at a time. The first key must be pressed while the
Welcome/Owner screen is being displayed:
Key Sequence
Function
1 Shortcut to PGM>GLOB>Sound Mode
2 Shortcut to PGM>GLOB>Key Beeps
3 Displays Boot, CPU and DSP versions
LIGHT Shortcut to PGM>GLOB>Light Mode
ATT Shortcut to PGM>GLOB>Atten Mode
0, 0 Shortcut to PGM>GLOB>Memory Info
0, 1 Destructive, clears working memory
and resets all Global settings to factory
defaults. Does not affect V-Scanners.
0, 2 Destructive, resets all Global settings to
factory defaults. Does not affect working
memory or V-Scanners.
0, 5
Destructive, executes EEPROM memory
test, then clears working memory and
resets all Global settings to factory
defaults. Does not affect V-Scanners.
0, CL Erases DSP APP Upgrade code, restores
factory DSP version
0, PGM Places radio in DSP APP firmware
upgrade mode
Hold PGM while
powering on
radio
Places radio in CPU firmware upgrade
mode
Power-On Password
Setting a power-on password can prevent anyone
other than you from using this scanner.
To set the power-on password
1. Press
PGM to enter Program Mode.
2. Press GLOB softkey.
3. Scroll to Set password, then press SEL key.
4. The confirmation menu for the power-on
password setting appears. Press
YES softkey.
5. Enter the four-character (four-digit)
password. You can enter the characters using
alphanumeric text entry method. When you
have finished entering characters, press OK
softkey to save the entry.
Note: You can cancel the entry by pressing
Cancl softkey.
To operate your scanner with power-on
password:
1. Turn
VOLUME clockwise to turn power on.
2. After the Welcome message is displayed, the
scanner prompts you to enter the password.
3. Enter your password.
4. If you entered the correct password, you will
be able to operate your scanner. If you have
entered the wrong password, the scanner
will generate error beep. Try entering your
password again.
To disable the power-on password
1. Press
PGM to enter Program Mode.
2. Press
GLOB softkey.
To Next Page
Loading...
