Radio Shack 20-106 - Loading V-Scanner to Main Memory

76
Scanner Memory
77
Scanner Memory
5. The scanner will prompt you to enter a name
for the stored V-Scanner. Use the standard
text entry method to type the name you wish
to use, then press the
OK softkey.
6. The scanner will write the contents of main
memory to the V-Scanner folder. This will take
approximately four seconds to complete.
Loading a V-Scanner Folder to Main Memory
1. Press FUNC, then PGM to enter V-Scanner
mode.
2. Press the Load softkey.
3. Press S or T to scroll to the desired
V-Scanner folder, then press the Load softkey.
4. The scanner will ask you to confirm that you
wish to overwrite the current contents of main
memory. Press the YES softkey to proceed, or
the NO softkey to abort.
The data transfer takes approximately 4 seconds
to complete.
Erasing V-Scanner Folders
1. Press FUNC, then PGM to enter V-Scanner
mode.
2. Press the Eras softkey.
3. Press S or T to scroll to the desired V-
Scanner folder, then press the Eras softkey.
4. Press the
YES softkey to delete current
contents, or press the NO softkey to abort.
Cloning
You can transfer the programmed data to and
from another PRO-106 (or PRO-197) scanner using
a connecting cable which has
1
/
8
-inch stereo
phone plugs on both ends (not supplied).
To clone the scanner data:
1. Turn on both scanners.
2. Connect the connecting cable to each
scanner’s PC/IF jack.
3. Press PGM, then the GLOB softkey to enter
the Global Settings menu.
4. On the SOURCE radio, scroll to Clone Send:
then press SEL when you are ready to send
data from your SOURCE radio to the TARGET
radio.
Both working memory and global settings are
transferred.
Note: The contents of working memory on the
TARGET radio will be overwritten immediately
when SEL is pressed on the SOURCE radio.
Memory Report
To display the memory usage report:
1. Press
PGM.
2. Press GLOB softkey to access the Global
menu.
3. Press S or T to scroll to Memory Info:.
4. Press SEL to view the memory usage report.
5. Press S or T to scroll the display.