To find objects with a specified text string:
1. Press
PGM to enter Program Mode.
2. Press EDIT softkey.
3. Press FIND softkey.
4. Press Text softkey.
5. Use the number keys to enter the text string
you wish to search for. Or press the Qtxt
softkey to use QuickText in your find text
screen. See “Appendix C: Text Entry and QuickText”Appendix C: Text Entry and QuickText”
on page 125 for information on entering text.
6. Press OK softkey to begin searching.
The radio will stop on any object where your
text string is found in the frequency, tag, or ID
fields as described above.
7. Press the Exit softkey to cancel the FIND
operation.
or Press EDIT softkey to edit object menu for the
selected object.
or Press
NEXT softkey to find the next object.
or Press MAN to begin monitoring the object in
Manual Mode.
or Press PGM to exit FIND and execute
programming tasks at the selected object
position.
Note: FIND keeps the last search text you
specified stored for subsequent FIND operations.
Filtering by Object Type
When browsing objects in Program Mode, you can
filter the objects that are displayed by their type.
1. Press the PGM to enter Program Mode.
2. Press EDIT softkey.
3. Press
W or X to scroll to display the filter
softkeys. The filter softkeys are as follows:
CONV
TGRP
TSYS
SRCH
STLK
4. Press the softkey that corresponds with that
object type to filter.
5. Press S, T, W or X to browse filtered objects.
Object Lockout
When an object is locked out, traffic is not
received on that object until it is unlocked, even if
the object is mapped to more than one Scan List.
Locking out an object locks it out “radio-wide”
until it is enabled by toggling the lockout setting.
Four types of lockout functions are available:
temporary lockout, permanent lockout, search
lockout, and talkgroup lockout.
Temporary Lockout
Temporary lockout locks out an object until
the scanner is turned off. When the scanner is
powered on again, all objects that have been
temporarily locked out are restored.
To temporarily lockout an object:
1. When the scanner stops on an object,
press
L/OUT.
or
1. In Manual Mode or Program Mode, press S,
T, W or X to select an object.
2. Press L/OUT.
The lowercase “l” in the display flashes to
indicate the object is temporary lockout.
To Next Page
Loading...
