CHECKING THE CODES (cont’d)
7. To check for codes of other devices, repeat
steps 4 to 6 (on the previous page), but
substitute the appropriate device key for
each device you are checking.Write down the
device’s code digits in the appropriate code
boxes on page 11.
8. To exit programming, press twice. The
display will return to the last-selected device
menu screen.
USING LEARNING
The RadioShack 8-in-One Remote includes a
Learning feature so you can add functions that
are unique to your home entertainment devices
(e.g.,VCR Tracking Up or Down). However,
there are some considerations:
LEARNING PRECAUTIONS
• Your original remote controls must be in
working order for learning to work properly.
• Learned keys are mode specific, so each one
can store a unique function for each mode.
• Learned keys can be used in macros (see
Using Macros on page 18).
• Do not use the following keys for learning:
P, SCREEN, M1 ~ M4, FAV SCAN, COM SKIP,
COM MUTE, or any Device Key.
• Learning capacity is approximately 16 to 25
keys, depending on the code being learned.
• If both learned and keymoved functions
are assigned to the same key, the last
programmed function will be stored.
• A learned function cannot be used as a
source for Keymover (see Using Keymover on
page 20).
• Certain device codes are not learnable,
including multi-frequency types, some
high-frequency ones, and other unusual
formats.
• For optimum learning, avoid high levels of
ambient light such as natural sunlight or
energy-efficient fluorescent lights.
NOTE: Please have your original remote controls
handy before programming learning. Be sure to press
each teaching key within 5 seconds of the previous
entry. Otherwise, the RadioShack 8-in-One Remote
will exit the programming mode.
PROGRAMMING A LEARNING KEY
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Press IR LEARN once. The IR Learn
programming screen will appear:
3. Press a device key once (i.e., CBL,SAT,TV, DVD,
AUD, VCR,AUX,or CD) to assign a mode for
learning. The selected device menu screen,
including ,will be displayed.
4. Place the RadioShack 8-in-One Remote
head-to-head (about 2" apart, as shown on
the next page) from your original remote
control.Also locate the key (on your original
remote control) that will serve as the teaching
function.
14 Checking The Codes/Using Learning
8-IN-ONE REMOTE POWERED BY KAMELEON
To Next Page
Loading...
Need help?
General
