Radio Shack Kameleon - Clearinga Macro; Using Keymover; Programming Keymover

USING MACROS
PROGRAMMING THE COM MUTE KEY (CONT’D)
5. To save the macro, press and hold P until
the bottom IR segment flashes twice. The
program keys will appear again.
6. To program the second macro, repeat steps 4
and 5, but substitute VOL
▲ for VOL▼ this
time (to raise the level four steps).
7. Exit programming by pressing once.The
display will return to the last-selected device
menu screen
.
CLEARING A MACRO
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Press MACRO once. The Macro programming
screen will appear:
3. Select the macro key to be cleared and press it
once. The last-selected device menu screen
will be displayed.
4. Press and hold P until the bottom IR
segment flashes twice. The program keys
will appear again.
5. Exit programming by pressing once.The
display will return to the last-selected device
menu screen
.
USING KEYMOVER
The RadioShack 8-in-One Remote includes a
Keymover feature that allows you to map (or
copy) keys from one mode (i.e., source mode) to
another mode (i.e., destination mode).
NOTE: Do not use any of the Device Keys as a source
or destination key.
PROGRAMMING KEYMOVER
For example, if your DVD player does not have
volume control, you can map those keys (i.e.,
VOL
▲, VOL ▼,and MUTE) from the TV mode to
DVD mode as follows:
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Press OTHER once. The Other programming
screen will appear:
3. Using the number keys,enter 9 9 4.
The bottom IR segment will flash twice.
20 Using Macros/Using Keymover
8-IN-ONE REMOTE POWERED BY KAMELEON
RS Kameleon 8in1 UG 7/9/03 1:03 PM Page 20