Radio Shack Kameleon User Manual

2. Press OTHER once. The Other programming
screen will appear:
3. Using the number keys,enter 9 8 5.The
screen will flash four times, confirming the
Tilt Switch is disabled. The program keys will
appear again.
4. Exit programming by pressing once.The
display will return to the last-selected device
menu screen
.
ENABLING THE TILT SWITCH
1. Perform steps 1 and 2 of the previous section,
Disabling The Tilt Switch.
2. Using the number keys,enter 9 8 5.The
screen will flash twice, confirming the Tilt
Switch is enabled. The program keys will
appear again.
3. Exit programming by pressing once.The
display will return to the last-selected device
menu screen
.
SETTING THE FINDER RECEIVER
The RadioShack 8-in-One Remote comes with
a Finder Transmitter that can be used to quickly
locate the main remote if it is accidentally lost
or misplaced.
At the factory, the Finder Receiver (inside the
remote) is set to wake up every few seconds,
listen for a signal from the Finder Transmitter,
and then emit an audible alert to pinpoint the
location of the main remote. This is a great
feature, but it does use extra battery power.
If you do not plan to use the Finder Transmitter,
we recommend turning off the remote’s Finder
Receiver to conserve battery life.
DISABLING THE FINDER RECEIVER
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Press OTHER once. The Other programming
screen will appear:
continued next page...
Setting The Tilt Switch/Setting The Finder Receiver 27
OWNER’S MANUAL
RS Kameleon 8in1 UG 7/9/03 1:03 PM Page 27

Radio Shack Kameleon Specifications

General

Brand	Radio Shack
Model	Kameleon
Category	Remote Control
Language	English