PROGRAMMING A MASTER POWER MACRO IN
MY SYSTEM MODE
A macro can be programmed onto the PWR
key to turn on or off as many as seven home
theater devices.
NOTE: This following example assumes the Home
Theater system contains a Satellite Receiver, a DVD
Player, an Audio Receiver, and a TV.
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Press MACRO once. The Macro programming
screen will appear:
3. Press PWR once.The last-selected device
menu screen, including , will be displayed.
4. Enter the macro sequence. For this example,
press SAT once, followed by PWR once. Next,
press DVD once, followed by PWR once. Then
press AUD once, followed by PWR once. Finally,
press TV once, followed by PWR once, and then
MY SYSTEM once.
5. To save the power macro, press and hold P
until the bottom IR segment flashes twice. The
program keys will appear again.
6. Exit programming by pressing once.The
display will return to the last-selected device
menu screen
.
7. To test the power macro, first make sure all
home theater devices selected in step 4 are
turned on.Aim the remote control at the
devices and press MY SYSTEM once, followed
by PWR once. The devices should turn off in
this order: Satellite Receiver, DVD Player,
Audio Receiver, and TV.
To turn on the devices on again in the same
order as above, press PWR once.
PROGRAMMING THE COM MUTE KEY
If desired, a two-state rotating macro can be
programmed onto the COM MUTE key, so a key
press will drop volume (in the CBL, SAT, TV, VCR
or AUX mode) to a preset level during a com-
mercial.When the program resumes, another
key press will raise it back to the original level.
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Press MACRO once. The Macro programming
screen will appear:
3. Press COM MUTE once.The last-selected
device menu screen, including , will
be displayed.
4. Enter the first macro sequence by pressing TV
once, then press VOL
▼ four times (to lower
the volume four steps).
continued on next page...
Using Macros 19
OWNER’S MANUAL
To Next Page
Loading...
Need help?
General
