Radio Shack Kameleon User Manual

PROGRAMMING
FAVORITE CHANNEL SCAN
In the CBL, SAT, TV, VCR,or AUX mode, the
RadioShack 8-in-One Remote can store a list of
up to 10 favorite channels, in any order, that will
be immediately scanned when you press FAV
SCAN once (see the following section, Using
Channel Scan).
NOTE: Favorite channels can only be programmed
for one mode. After programming, if FAV SCAN is
pressed while in another mode, the remote control will
start a normal channel scan instead (if applicable to
the selected device).
1. Press and hold P until the bottom IR segment
flashes twice. The program keys will appear:
2. Select a Favorite Channel Mode by pressing
CBL, SAT, TV, VCR,or AUX once. The bottom IR
segment flashes once as the selected device
key animates.
3. Press OTHER once. The Other programming
screen will appear:
4. Using the number keys,enter 9 9 6.The
screen will flash twice and display the
Favorite Channel programming screen.
NOTE: If the bottom IR segment displays one long
flash, an error has occurred. Try repeating this step.
5. Using the number keys,enter a favorite
channel number (e.g., 0 1 2). Then press
P once.
NOTE: If the original remote control required
pressing an Enter key to change the channel, also
press the ENTER key after the channel number
(e.g., 0 1 2 ENTER).
6. If desired, repeat step 5 for each channel to be
stored, up to a total of 10 channels.
NOTE: After storing 10 channels, the remote control
will exit the Favorite Channel programming screen
and again display the program keys.
7. To exit programming with less than
10 favorite channels stored, press twice.
The display will return to the last-selected
device menu screen.
USING CHANNEL SCAN
In the CBL, SAT, TV, VCR,or AUX mode, use FAV
SCAN to start a 3-second scan of all favorite
channels (if programmed – see Programming
Favorite Channel Scan in the previous section)
and/or all channels for the selected mode.
1. If Favorite Channel Scan has been set up, skip
to step 2. Otherwise, press CBL, SAT, TV, VCR,
or AUX once. The bottom IR segment flashes
once as the selected device key animates.
2. Press FAV SCAN once. The IR segments will
display outgoing animation as each channel
is changed.
•IfFavorite Channel Scan has been set up,
scanning of favorite channels will start
and cycle through stored channels for
3 minutes or until any key press stops it.
22 Programming Favorite Channel Scan/Using Channel Scan
8-IN-ONE REMOTE POWERED BY KAMELEON
RS Kameleon 8in1 UG 7/9/03 1:03 PM Page 22

Radio Shack Kameleon Specifications

General

Brand	Radio Shack
Model	Kameleon
Category	Remote Control
Language	English