RadioLink AT10II User Manual

Radiolink Electronic Ltd
www.radiolink.com
57
4.3.1
AILE DIFF (FIND IN ACRO FUNCTION MENU 3.3.5)
4.3.2 FLAPERON (GLID 1A+1F, FIND IN ACRO FUNCTION MENU 3.3.3)
4.3.3 V-TAIL (FIND IN ACRO FUNCTION MENU 3.3.10)
4.3.4 OFFSET (GLID 2A+2F):
Additional flight conditions are available specifically for sailplanes.
These additional flight conditions contain different offset trims to make the sailplane perform certain
maneuvers more easily. Aileron differential functions may be set to provide separate rates per
condition selected.
Prior to setting up OFFSET, you must active the conditions and assign the switches in the
CONDITION/FUNCTION.
Unnecessary fuselage motion is generated when there are sudden changes in the servo position
and variations in the operating time between channels can be suppressed by using the delay
function.
Note: The same delay amount for elevator and rudder is recommended when using V-tail
function.
The AT10II provides 5 additional setups along with the normal flight condition. (NORMAL,
START, SPEED, DISTANCE and LANDING) These offset trims have same setting abilities
basically except the switch and dial assignment. For an example of trim settings, please see the
following:
ADJUSTABILITY:
• Separate adjustments for each aileron, elevator, rudder and flap servo, for each condition.
• SWITCH G (AT10) or E (AT10) is programmed for NORMAL, START, and SPEED trims. SWITCH
C is programmed for DISTANCE and LANDING trims. These switch/position assignment is
adjustable. (CONDITION/FUNCTION)
• TRIM item (Digital trim operation mode):
NORM: normal trim operation mode.
MIX: offset rate trim operation mode while mixing is on.
• Optional assignable knob (CAMBER MIX) to allow trimming in flight of the aileron and flap action
of each flight condition.
• During OFFSET operation, the aileron and elevator travels are displayed on each trim display in
the Startup screen.
Goals
Steps
Inputs
Set up a START to gain
maximum possible lift on launch.
Each Aileron: 50%. Each Flap:
100%.
Elevator: -5% to compensate.
SWITCH (AT10II=G,
AT10II=E.)
Open OFFSET function
to BASIC . again to ADVANCE
to OFFSET,
Switch to the START condition.
G or E from NORMA to START

RadioLink AT10II Specifications

General

Brand	RadioLink
Model	AT10II
Category	Remote Control
Language	English