RadioLink AT10II - Camber Mixing for Wing Control

Radiolink Electronic Ltd
www.radiolink.com
59
ADJUSTABILITY
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER): The operation reference point of flap can be offset. -100% to +100%,
with a default of 0%.
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please
set up after pressing DIAL for 1 second and canceling an alarm display.
Goals
Steps
Inputs
Ex: Set the maximum
travel of 35% of the
total flap travel.
Open the CAMBER FLAP
function.
to BASIC . again to ADVANCE
to CAMBER-FLP,
Adjust the up/down trim
amount separately.(Ex: adjust
to 35%)
to FLP 。
VR (A), to 35%，
VR (A), to 35%， 。
Repeat.
Or: adjust the center position
of flap servo
to CENTER , to desired point.
Close
4.3.7 Camber Mixing:
This function adjusts the mixing rate of camber operation which operates the wing camber (ailerons
and flaps) in the negative and positive directions. The aileron, flap, and elevator rates can also be
adjusted independently and attitude changes caused by camber operation can be corrected.
Also the operation reference point of camber control can be offset. (PRE)
Note:
Camber control is not assigned at initial.
ADJUSTABILITY: