RadioLink AT10II - Attitude Mode Settings for Multirotors

Radiolink Electronic Ltd
www.radiolink.com
83
Goals
Steps
Inputs
Set the
ATTITUDE of
MULTIROTO
R.
In ADVANCE menu find the
ATTITUDE function.
urn on the transmitter, for 1 sec. to BASIC
menu (If ADVANCE, again)
Press MODE to ATTITUDE
Assign the switch to control attitude.
Ex: SW3 is SWC，SW2 is SWB
to SW3, , to SWC，
to SW2, , to SWB，
Set the rate in each attitude.
Ex: ATTI is 60%.
to rate-ATTI, ， to 60%，
Close
6.2.2 THROTTLE CURVE (see ACRO 3.3.14)
6.2.3 PROG. MIX (see ACRO 3.3.1)
AT10II Using Tutorials
RadioLink AT10 + R10D Binding
https://www.youtube.com/watch?v=rhdB6KgVsMw
RadioLink AT10 + PRM-01 Telemetry Module
https://www.youtube.com/watch?v=uWSxWrYUwAg
AT10 Firmware Upgrade
https://www.youtube.com/watch?v=SU-AclRNwWY&t=47s
RadioLink AT10 and NAZA in SBus
https://www.youtube.com/watch?v=nxU8RnwjTs4&t=372s
Mission Planner Calibration and Radiolink AT10 setup Flight Modes
https://www.youtube.com/watch?v=3jtOA4m1csA&t=26s
3 Axis CNC Gimbal with Storm32 Controlled by AT10
https://www.youtube.com/watch?v=iPna6LhoBZ8&t=19s
RADIOLINK AT10. SETUP FOR APM 2.6. APM 2.8
https://www.youtube.com/watch?v=S7DdYLgSZ7E&t=12s