RadioLink AT10II User Manual

Radiolink Electronic Ltd
www.radiolink.com
58
Set the rates. (Ex: AIL 50%,
FLP 100%, ELEV -5 %.)
to AIL , to 50%,
Repeat for FLP and ELEV.
Close
4.3.5 START DELAY (GLID 1A+1F only):
START DELAY automatically switch the offset trims (OFFSET) from the START condition's trims to
the normal condition’s trims after proceeding the delay time (max.10sec.) which is set by the -DLY-
item when activating the START condition. (It is convenient for hand launch glider.)
Note: The same delay amount for elevator and rudder is recommended when using V-tail
function.
ADJUSTABILITY:
• Delay time (-DLY-) range of 0 to 100%. The delay time is 10 second at 100%.
Goals
Steps
Inputs
Ex: delay time=5
second.
Open ADVANCE menu,
then open START DELAY.
to BASIC . again to ADVANCE
to START-DLY,
Activate the function
to MIX , to OFF or ON
Set the delay time.
(Ex:50% each surface)
to ELEV , to 50%
to RUDD , to 50%
Repeat as needed.
Close
4.3.6 CHAMBER-FLP
CAMBER FLAP assigns the primary flap control [defaults to VR (A)] to allow trimming in flight of the
flap action. The up and down travel of each flap (camber flaps: FLP1/2) can be adjusted
independently. Also the center position of flap servo can be offset.
Note: If FLAP-TRIM is activated, you can not use CAMBER FLAP function simultaneously.

RadioLink AT10II Specifications

General

Brand	RadioLink
Model	AT10II
Category	Remote Control
Language	English