RadioLink AT10II - Aileron Differential (AILE-DIFF) Setup

Radiolink Electronic Ltd
www.radiolink.com
43
FLAP-TRIM assigns the primary FLAPERON control [defaults to VR(A)] to allow trimming in flight of
the flap action of FLAPERON.
Note: Even if FLAP-TRIM is made active with AIL-DIFF, it will not have any effect. The ONLY
function that allows control of the ailerons as flaps in the AIL-DIFF configuration is AIRBRAKE. Most
modelers use AIRBRAKE, or programmable mixes, to move the flaps to a specified position via
movement of a switch.
FLAP-TRIM may also be used as the primary flap control in flight. By doing so, you can assign CH6
to a 3-position switch, with a "SPOILERON", neutral, and "FLAPERON" position, and even adjust
the percentage traveled as FLAPERON/SPOILERON by changing the Flap Trim travel.
Goals
Steps
Inputs
Add FLAP-TRIM to
allow the model’s ailerons
to be trimmed together as
flaps at any time during
the flight, with a
maximum travel of 5% of
the total flap travel set in
FLAPERON.
Open FLAP-TRIM function
to BASIC again to ADVANCE
to FLAP-TRIM.PUSH.
The function is automatically activate with FLAPERON; however the default
travel is 0.
Adjust the travel available to
the FLAPERON when turning
the CH6 dial.
to 5%
Close
3.3.5 AILE DIFF (ACRO/ GLID 2A+1F/ GLID 2A+2F)
ACRO GLID (2A+1F)/GLID (2A+2F)
Aileron differential is primarily used on 3 or 4-servo wings, with one servo operating inboard flap on
CH6 or CH5 & CH6, and AILE-DIFF controlling proper aileron operation of 2 aileron servos, plugged
into CH1 and CH7. The ailerons can not be moved like flaps when using AILE-DIFF, except if using
AIRBRAKE. (Note that even if you make FLAP-TRIM active while using AILE-DIFF, it will not have
any effect. ONLY AIRBRAKE controls the ailerons as flaps in the AILE-DIFF configuration.)
Note: When changing the polarity of a rate in camber-flap, "change rate dir?" is displayed for a
check. Please set up after pressing DIAL for 1 second and canceling an alarm display. (GLID only)
•
FLAP function allows you to set up 1 or 2 servos for flap action.
• The separate AILE-DIFF settings for each condition can be set. (GLID only)
Goals
Steps
Inputs
Activate twin aileron servos
using AILE-DIFF.
Note that the function
defaults to no difference in
down travel vs. up travel. If
you want differential travel,
simply adjust each side. (Ex:
90%)
Open the FLAPERON.
to BASIC menu, again to ADVANCE
to AILE-DIFF .PUSH.
Activate the function.
to MIX，PUSH. to ACT
Optional: adjust the
up/down travel for 2
servos..(Ex:90% down)
to AILE1 AILERON STICK. to 90%
to AILE2, AILERON STICK， to 90%