RadioLink AT10II User Manual

Radiolink Electronic Ltd
www.radiolink.com
4
1.1.3 Compatible receivers
AT10II is a 12 channels transmitter, support 2.4G DSSS and FHSS spread spectrum working
synchronously, 16 channels pseudo random frequency hopping.
AT10II sells with dual antenna receiver R12DS which support SBUS and PWM signal output
simultaneous, signal coverage all around, never afraid of hilly terrain.
Besides R12DS, AT10II also compatible with Radiolink R6DS, R9DS, R10DS and super mini 10
channels receiver R6DSM and 12 channels mini dual antenna receiver R12DSM.
R6DS, is a 6 channels receiver when working with PWM signal while it is a 10 channels receiver
when working with SBUS or PPM signal.
R9DS, is a 9 channels receiver when working with PWM signal while it is a 10 channels receiver
when working with SBUS signal.
SWITCH B
CH9
D/R,EXP
-CH4(RUDD)
CH9
D/R,EXP
-CH4(RUDD)
SPOILER-MIX
CH9
D/R,EXP
-CH4(RUDD)
CH9
D/R,EXP
-CH4(RUDD)
SWITCH C
ADVANCED
MENU-
ELEV-FLAP
up =
ELE-FLP
on
center/down=
IDLE-DOWN
down =
AIRBRAKE
on
up =
ELEV-FLAP
on
center =
CONDITION
Distance
down =
CONDITION
Landing
CH7
GOVERNOR
ATTITUDE
SWITCH D
D/R,EXP
-CH1(AILE)
D/R,EXP
-CH1(AILE)
D/R,EXP
-CH1(AILE)
D/R,EXP
-CH1(AILE)
SWITCH E or
G*
THR- CURVE
down =
CONDITION
Start
up =
CONDITION
Speed
CONDITION
IDLE-UP
THR-CURVE
SWITCH F or
H*
——
——
CH5
GYRO-SENSE
CONDITION
IDLE-UP
——
SWITCH G
or E*
GYRO-SENSE
——
CONDITION
THR-HOLD
——
SWITCH H
or F*
——
.——
THR CUT
MOTOR CUT
KNOB A
CH6
(
flap trim if
FLAPERON
is off)
CH6
CAMBER-FLP
FLAP-TRIM
HOV- PIT
CH6
KNOB B
CH8
CH8
SPOILER-MIX
HOV-THR
CH8
KNOB C
CH7
(disabled if
AIL-DIFF
on)
CH7
HI/LO-PIT
CH7
SLIDER D
——
CH5
——
——

RadioLink AT10II Specifications

General

Brand	RadioLink
Model	AT10II
Category	Remote Control
Language	English