MultiRAE User’s Guide
72
AutoRAE 2
1. Follow the instructions in the AutoRAE 2 User’s Guide to connect the AutoRAE 2 and the PC
using the included cable.
2. Make sure the monitor is either turned off or is in AutoRAE 2 Communications Mode.
3. Place the instrument into the cradle face-down, making sure that it is aligned correctly with
the contacts on the AutoRAE 2 Cradle’s charging port. There are two alignment points on one
side and one alignment point on the other side, designed to mate with matching points on the
bottom of the MultiRAE.
4. Press in on the capture mechanism to lock the MultiRAE in place.
5. Start up the ProRAE Studio II software, enter a password, and detect the instrument following the
directions provided in the ProRAE Studio II User’s Guide.
6. Follow the instructions in the ProRAE Studio II User’s Guide to download the datalog, configure the
instrument settings, or to update the MultiRAE’s firmware.
7. When you are done, press [Y/+] to exit the AutoRAE 2 Communications Mode on the MultiRAE. The
instrument returns to operating in Normal mode.
To Next Page
Loading...
