Instruction of Displaying Message
1-1 Boot Screen
1-2 Main Screen : Displaying RAID mode & IP address
2-1 System Information
2-1-1 System Status
HD1 : First HDD Status (Upper one)
HD2 : Second HDD Status (Lower one)
OK : Normal / OFF : No HDD is installed / BAD : HDD Failed
F1 : Fan Status
O: Normal / X : Fan Failed
T : Temperature
O : Normal / X : Overheating (Over setting value)
2-1-2 IP Mode & RAID Mode
IP Mode : Static or DHCP
RAID Mode : Displaying RAID mode
2-1-3 Fan Rotation Speed & Temperature
F1 : Fan rotation speed
F2 : No function
Temp : Current temperature
2-1-4 Default Value of Overheating Alarm
Temp : Temperature to start Smart Fan
Alarm : Overheat temperature
2-1-5 Firmware Version
2-1-6 Displaying the HDDs information
2-2 Network Information
2-2-1 IP address of DHCP sever
2-2-2 IP address of Network Mask
2-2-3 IP Address of Gateway
2-2-4 IP address of DNS sever
2-3 System Setting
2-3a Asking for inputting 8 digits password, the default password is 00000000
2-3-1 Network Setting
2-3-1-1 Start DHCP function or not
To Next Page
Loading...
