EasyManua.ls Logo

Ramsey Electronics COM3010 - Specifications

Ramsey Electronics COM3010
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
100
Features:
• Display: 2 Vacuum Fluorescent graphical displays, 16 x 140 pixels
• Memories: 100 sequences of 100 registers, plus system memories
• Sweep Features: Linear, octave, and decade of up to 1000 pts for sweeping generator
• Scanner Mode: Allows scanning through a sequence of 100 stored settings
• Sinad Meter: Display reading from –30 dB of SINAD to 0 dB. Loop-back audio for
tested equipment
• Frequency Counter: Measures frequency error to 1Hz in three counter modes
• Battery Meter: Displays charge left in batteries
• Reverse Power Protection: Generate output protected, switches into 100 watts
internal load and automatically displays power in dBm or watts
• Power Meter: Displays power when unit is keyed into the generator output. Reads
from 23 dBm to +50 dBm, 0.5 dB, selectable dBm or watts
• Attenuator Output: -30 dB attenuator output from internal load for monitoring
• Calibrated RSSI Meter: 80 dB of range on receiver side., -40 dBm to -120 dBm
Generate:
• Frequency: 100 kHz to 1.0 GHz, 1 Hz steps
• Frequency Accuracy: 0.1ppm standard
• RF output Level: -140 dBm to 0 dBm, 0.1 dBm steps
• Level Accuracy: 1 dB , 500 kHz to 1.0 GHz; 2 dB 100 kHz to 500 kHz
• Units: dBm, uV ,mV
• Leakage: Better than 1 uV, 2 turn loop, 1” dia. at 1”
Spurious:
• Harmonics: -30 dBc typical above 1 MHz
• Non-harmonics: -50 dBc typical
• FM Modulation: 75 kHz max in 0.1 Hz steps
• FM Bandwidth: 0.1 Hz to 75 kHz
• Accuracy: 0.1ppm
• AM Modulation: 0 to 75% in 1% steps to -100 dBm, 0-50% to -140 dBm
• AM Bandwidth: 10 Hz to 10 kHz
• Accuracy: 5%
• Distortion: Less than 5%
Modulation Types
• Internal: 0.1 Hz to 3000.0 Hz, 0.1 Hz steps
• External: 0.1 Hz to 3000.0 Hz, 0.1 Hz steps, digital and analog selectable
• CTS Encode: 0.1 Hz to 999.9 Hz at .75 Hz default deviation, variable from 0.1 Hz to
2 kHz deviation
• DPL Encode: 750 Hz, variable from 0.1 Hz to 2 kHz, all supported codes
• Two-Tone Paging Each tone, 0.1 Hz to 3000.0 Hz, Group, Voice, Tone, Battery Save
page modes.
COM3010 SPECIFICATIONS
Property of Ramsey Electronics, Inc.
Do not reproduce or distribute.

Table of Contents

Related product manuals