Contents
R&S
®
NRPxxS(N)
4User Manual 1177.5079.02 ─ 10
6.3 Common Settings....................................................................................................... 43
6.4 Measurement Modes...................................................................................................44
6.5 Settings........................................................................................................................ 48
7 Firmware Update..................................................................................57
7.1 Hardware and Software Requirements..................................................................... 57
7.2 Updating the Firmware............................................................................................... 57
8 Replacing an R&S NRP-Zxx with an R&S NRPxxS(N) ..................... 62
8.1 Most Important Differences........................................................................................62
8.2 Prerequisites............................................................................................................... 62
9 Remote Control Commands................................................................64
9.1 Conventions Used in SCPI Command Descriptions................................................64
9.2 Notations......................................................................................................................64
9.3 Common Commands.................................................................................................. 66
9.4 Preparing for the Measurement................................................................................. 70
9.5 Controlling the Measurement.................................................................................... 72
9.6 Configuring and Retrieving Results..........................................................................87
9.7 Configuring the Measurement Modes.......................................................................92
9.8 Configuring Basic Measurement Parameters........................................................ 104
9.9 Calibrating/Zeroing the Power Sensor ...................................................................125
9.10 Testing the Power Sensor........................................................................................ 127
9.11 Configuring the System............................................................................................128
9.12 Using the Status Register........................................................................................ 140
10 Performing Measurement Tasks - Programming Examples.......... 144
10.1 Performing the Simplest Measurement.................................................................. 144
10.2 Performing the Fastest Measurement in Continuous Average Mode.................. 144
10.3 Performing a Buffered Continuous Average Measurement.................................. 146
10.4 Performing Trace Measurements............................................................................ 148
10.5 Trace Measurement with Synchronization to Measurement Complete............... 149
11 Remote Control Basics......................................................................151
11.1 Remote Control Interfaces and Protocols.............................................................. 151
11.2 SCPI Command Structure........................................................................................ 155
11.3 Status Reporting System......................................................................................... 162
To Next Page
Loading...
Need help?
General
