R&S NRP8S - System:communicate:network:ipaddress:info; System:communicate:network:ipaddress:mode; System:communicate:network:ipaddress:subnet:mask; System:dfprint<Channel

Remote Control Commands
R&S
®
NRPxxS(N)
131User Manual 1177.5079.02 ─ 10
Manual operation: See "Gateway" on page 56
SYSTem:COMMunicate:NETWork:IPADdress:INFO?
Effective only for the R&S NRP LAN power sensors.
Queries the network status information.
Usage: Query only
SYSTem:COMMunicate:NETWork:IPADdress:MODE
<mode>
Effective only for the R&S NRP LAN power sensors.
Sets whether the IP address is assigned automatically or manually.
Parameters:
<mode> AUTO | STATic
AUTO
Assigns the IP address automatically, provided the network sup-
ports DHCP.
STATic
Enables assigning the IP address manually.
*RST: AUTO
Example:
SYST:COMM:NETW:IPAD:MODE AUTO
The IP address is assigned automatically.
Manual operation: See "DHCP" on page 56
SYSTem:COMMunicate:NETWork:IPADdress:SUBNet:MASK <netmask>
Effective only:
●
For the R&S NRP LAN power sensors.
●
If SYSTem:COMMunicate:NETWork:IPADdress:MODE is set to STATic.
Sets the subnet mask.
Parameters:
<netmask>
Example:
SYST:COMM:NETW:IPAD:SUBN:MASK '255.255.255.0'
Sets 255.255.255.0 as subnet mask.
Manual operation: See "Subnet Mask" on page 55
SYSTem:DFPRint<Channel>?
Reads the footprint file of the sensor.
Configuring the System