Browser-Based User Interface
R&S
®
NRPxxS(N)
56User Manual 1177.5079.02 ─ 10
Gateway
Sets the address of the default gateway, that means the router that is used to forward
traffic to destinations beyond the local network. This router is on the same network as
the instrument.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:GATeway on page 130
DHCP
Selects the mode for assigning the IP address.
"Auto"
Assigns the IP address automatically, provided the network supports
DHCP (dynamic host configuration protocol).
"Static"
Enables assigning the IP address manually.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:MODE on page 131
Apply Network Settings
After you have made the required network settings changes, apply them to the power
sensor by clicking "Apply Network Settings".
Sensor Name
Sets the sensor name. The sensor name is displayed in the title bar of the web user
interface, see Figure 6-1.
If you do not specify a sensor name, the hostname is used as default. See also
SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname on page 129.
Remote command:
SYSTem[:SENSor]:NAME on page 139
Firmware Update
Opens a dialog to start the firmware update. For further information, see Chapter 7.2.2,
"Using the Web User Interface", on page 60.
Alternatively, you can the Firmware Update for NRP Family program. See Chap-
ter 7.2.1, "Using the Firmware Update for NRP Family Program", on page 58.
Remote command:
SYSTem:FWUPdate on page 133
SYSTem:FWUPdate:STATus? on page 133
Settings
To Next Page
Loading...
Need help?
General
