Troubleshooting
R&S
®
NRPxxS(N)
176User Manual 1177.5079.02 ─ 10
12.3 Problems during a Firmware Update
The firmware update is described in Chapter 7, "Firmware Update", on page 57.
Solutions for potential problems that can occur when using the Firmware Update for
NRP Family, see "Troubleshooting" on page 59.
Firmware update was interrupted
If, for example, a power cut happened during the firmware update, problems can occur.
1. Perform the firmware update again. Sometimes, a further update fixes the prob-
lems.
2. If the power sensor is not accessible any more, contact the service.
12.4 Cannot Establish a LAN Connection
If you have problems to establish a LAN connection as described in Chapter 3.5.2,
"Setting Up a LAN Connection", on page 16, try the following measures:
●
Use the Configure Network Sensor component of the R&S NRP Toolkit, see "Con-
figure Network Sensor" on page 29.
●
"Troubleshooting for peer-to-peer connections" on page 20
Cannot Establish a LAN Connection
To Next Page
Loading...
Need help?
General
