R&S NRP8S - Using the Status Register

Remote Control Commands
R&S
®
NRPxxS(N)
140User Manual 1177.5079.02 ─ 10
The sensor name that you specify here is independent from the hostname of the sen-
sor. However, if the sensor name is not specified, it defaults to the hostname.
Example:
SYST:NAME "InputModule-X5"
Results in a display as shown in Figure 9-12.
Figure 9-12: Sensor Name
Parameters:
<sensorname>
Manual operation: See "Sensor Name" on page 56
SYSTem:VERSion?
Queries the SCPI version that the command set of the sensor complies with.
Example:
SYST:VERS?
Query
1999.0
Response: SCPI version from 1999.
Usage: Query only
9.12 Using the Status Register
Further information:
●
Chapter 11.3, "Status Reporting System", on page 162
Contents:
● General Status Register Commands.................................................................... 141
● Reading Out the CONDition Part.......................................................................... 141
● Reading Out the EVENt Part.................................................................................141
● Controlling the ENABle Part..................................................................................142
● Controlling the Negative Transition Part............................................................... 142
● Controlling the Positive Transition Part................................................................. 143
Using the Status Register