To Next Page

To Previous Page

Browser-Based User Interface

R&S

NRPxxS(N)

44User Manual 1177.5079.02 ─ 10

<State> ← Offset

Enables or disables the usage of the level offset.

Remote command:

[SENSe<Sensor>:]CORRection:OFFSet:STATe on page 111

<Value> ← Offset

Adds a fixed level offset in dB to account for external losses.

Remote command:

[SENSe<Sensor>:]CORRection:OFFSet on page 111

S-Parameter

Selects the mode used for the S-parameters. S-parameters are used to compensate

for a component (attenuator, directional coupler) connected ahead of the sensor.

Averaging

See "Averaging Mode" on page 52.

6.4 Measurement Modes

Describes the parameters for the available measurement modes.

● Continuous Average Mode......................................................................................44

● Burst Mode..............................................................................................................45

● Timeslot Mode.........................................................................................................46

● Trace Mode............................................................................................................. 47

6.4.1 Continuous Average Mode

Describes the parameters of the continuous average measurement.

Further information:

●

Chapter 9.7.1, "Continuous Average Measurement", on page 93

Detailed description of the continuous average mode and its remote commands

Access: main dialog of the web user interface > navigation pane > "Continuous Aver-

age"

Aperture Time................................................................................................................45

Duty Cycle.....................................................................................................................45

Smoothing.....................................................................................................................45

Measurement Modes

R&S NRP8S User Manual

Other manuals for R&S NRP8S