Browser-Based User Interface
R&S
®
NRPxxS(N)
47User Manual 1177.5079.02 ─ 10
Remote command:
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:COUNt on page 98
Nominal Width
Sets the length of a timeslot in seconds.
Remote command:
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:WIDTh on page 99
Start Exclude
Sets a time that is to be excluded at the beginning of the measurement period.
Remote command:
[SENSe<Sensor>:]TIMing:EXCLude:STARt on page 109
End Exclude
Sets a time that is to be excluded at the end of the measurement period.
Remote command:
[SENSe<Sensor>:]TIMing:EXCLude:STOP on page 109
Trigger Source
See "Trigger Source" on page 54.
Trigger Level
See "Trigger Level" on page 54
6.4.4 Trace Mode
Describes the parameters of the trace measurement.
Further information:
●
Chapter 9.7.4, "Trace Measurement", on page 99
Detailed description of the trace measurement mode and its remote commands
Access: main dialog of the web user interface > navigation pane > "Trace"
Measurement Modes
To Next Page
Loading...
