R&S NRP8S User Manual

Remote Control Commands
R&S
®
NRPxxS(N)
141User Manual 1177.5079.02 ─ 10
9.12.1 General Status Register Commands
STATus:PRESet.............................................................................................................141
STATus:QUEue[:NEXT]?................................................................................................ 141
STATus:PRESet
Resets the edge detectors and ENABle parts of all registers to a defined value.
Usage: Event
STATus:QUEue[:NEXT]?
Queries the most recent error queue entry and deletes it.
Positive error numbers indicate sensor specific errors. Negative error numbers are
error messages defined by SCPI.
If the error queue is empty, the error number 0, "No error", is returned.
Usage:
Query only
9.12.2 Reading Out the CONDition Part
Further information:
●
Chapter 11.3.2, "Structure of a SCPI Status Register", on page 163
STATus:DEVice:CONDition?
STATus:OPERation:CALibrating:CONDition?
STATus:OPERation:CONDition?
STATus:OPERation:LLFail:CONDition?
STATus:OPERation:MEASuring:CONDition?
STATus:OPERation:SENSe:CONDition?
STATus:OPERation:TRIGger:CONDition?
STATus:OPERation:ULFail:CONDition?
STATus:QUEStionable:CALibration:CONDition?
STATus:QUEStionable:CONDition?
STATus:QUEStionable:POWer:CONDition?
STATus:QUEStionable:WINDow:CONDition?
Usage:
Query only
9.12.3 Reading Out the EVENt Part
Further information:
●
Chapter 11.3.2, "Structure of a SCPI Status Register", on page 163
STATus:DEVice[:EVENt]?
STATus:OPERation:CALibrating[:SUMMary][:EVENt]?
STATus:OPERation[:EVENt]?
Using the Status Register

R&S NRP8S Specifications

General

Brand	R&S
Model	NRP8S
Category	Accessories
Language	English