EasyManuals Logo

R&S NRP8S User Manual

R&S NRP8S
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
Browser-Based User Interface
R&S
®
NRPxxS(N)
53User Manual 1177.5079.02 ─ 10
"Moving"
Specifies that a measurement result is not output until the entire mea-
surement has been completed. This means that the number of mea-
surement cycle repetitions is equal to the set averaging factor. If the
averaging factor is large, the measurement time can be very long.
Remote command:
[SENSe<Sensor>:]AVERage:TCONtrol on page 107
Auto Measurement Time
Available only if "noise content" is set under "<Mode>" on page 52.
Sets an upper limit for the settling time of the auto-averaging filter, thus limiting the
length of the filter.
Remote command:
[SENSe<Sensor>:]AVERage:COUNt:AUTO:MTIMe on page 106
6.5.3 Trigger Settings
Describes the trigger parameters. You can define the conditions that have to be fulfilled
for a measurement to be triggered.
Further information:
Chapter 9.5.5, "Configuring the Trigger", on page 81
Chapter 9.5, "Controlling the Measurement", on page 72
Access: main dialog of the web user interface > navigation pane > "Trigger"
Trigger Source...............................................................................................................54
<Source>........................................................................................................ 54
<Slope>...........................................................................................................54
Trigger Level................................................................................................................. 54
Trigger Delay.................................................................................................................54
Dropout......................................................................................................................... 54
Holdoff...........................................................................................................................54
Hysteresis..................................................................................................................... 54
Settings

Table of Contents

Other manuals for R&S NRP8S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the R&S NRP8S and is the answer not in the manual?

R&S NRP8S Specifications

General IconGeneral
BrandR&S
ModelNRP8S
CategoryAccessories
LanguageEnglish

Related product manuals