Replacing an R&S NRP-Zxx with an R&S NRPxxS(N)
R&S
®
NRPxxS(N)
63User Manual 1177.5079.02 ─ 10
After the new version of the R&S NRP Toolkit is installed, you can connect the R&S
NRPxxS(N) power sensor to the computer and use it with Rohde & Schwarz software
applications or your own programs.
Software applications and firmware
Software/firmware Prerequisites
R&S NRPV See the release notes and the manual of the R&S NRPV.
R&S Power Viewer See the release notes and the manual of the R&S Power Viewer.
R&S NRP2 Install firmware version 7.11 or higher.
R&S signal generators, spectrum
analyzers or other instruments
Install the latest firmware version (released December 2014 or later).
Prerequisites
To Next Page
Loading...
