Rational SelfCookingCenter series - Communication: RATIONAL Remote App Networking; RATIONAL Remote App Networking

Communication
184 / 203
Networking appliances with the RATIONAL Remote App
The RATIONAL Remote App offers the convenience of monitoring your RATIONAL
SelfCookingCenter® (year of construction from 09/2011) from your iPhone or iPad. Once a
connection between the SelfCookingCenter® and the iPhone or iPad has been established
via the local area network, the entire content of the SelfCookingCenter® screen will be
transmitted and displayed. It also allows you to control the SelfCookingCenter® remotely.
The following conditions must be fulfilled before you can use the RATIONAL Remote App:
-
Compatible for use with all SelfCookingCenter
®
from construction year 09/2011 onwards.
-
This SelfCookingCenter
®
features a network card as standard.
- It must also be ordered or upgraded later with the Ethernet interface option.
- IP address, subnet mask and a gateway must be programmed on the appliance.
-
The SelfCookingCenter
®
can then be connected to the network just like a PC.
- The iPhone or iPad on which the RATIONAL Remote App is used must be on the same
network or WLAN to which the SelfCookingCenter® is connected.
- You cannot use the display or control if the iPhone or iPad is on a different network or if
there is only a mobile network connection (3G, 4G, LTE).
Connection settings
In order to connect your SelfCookingCenter® with the App, create a new device under device
management. For this you will need a host (IP address) and a port (default 5900).
You will find the information required in your SelfCookingCenter® as follows:
- Step 1: On the start screen, open the MySCC setting menu
- Step 2: Select the System management submenu
- Step 3: In this submenu, select the Network settings option. You can change the network
settings with this function.
If your SelfCookingCenter® is not yet connected to a network, please configure this first and
then restart the appliance.