Rauch MDS 8.2 - Page 100

Fig. 57: Boundary spreading
T Headland track X Working width
u
Place the headland track [T] half the working width [X] away from the border of the field.
When continuing spreading in the field after headland track spreading note the following:
u
Swivel the TELIMAT boundary spreading unit out of the spreading area (upper position).
The TELIMAT boundary spreading unit is inactive.
You are spreading over the entire working width.
9. Spreading operation
100
5902916 MDS 8.2/14.2/18.2/20.2