The version Q machines are equipped with electronic slide actuators for application rate
adjustment.
The electronic metering slide actuator is described in a separate operator's manual for the control
unit. This operator’s manual is an integral part of the control unit.
NOTICE!
Property damages caused by incorrect positioning of the metering slide
If the stop levers are positioned incorrectly, the operation of the actuators via the QUANTRON-A
operating unit may cause damage to the metering slides.
u
Always clamp the stop levers at the maximum scale position.
For version Q, the stop is firmly fixed in a position outside the scale with a fillister head screw [1].
Fig. 40: Scale for setting the application rate (on the right in the direction of travel, version Q)
9.4 Setting the working width
Various spreading discs are available for implementation of the working width depending on the
fertilizer type.
9. Spreading operation
MDS 8.2/14.2/18.2/20.2 5902916
75
To Next Page
Loading...
