Rauch MDS 8.2 - Spreading Vane Replacement; Replacing the Extension Vane

Case 2: The distance is less than 1 mm.
u
Place washers of an appropriate thickness evenly underneath the 3 mounting screws.
Case 3: The agitator cannot be snapped into place.
• The cross pin is too low.
u
Place washers of an appropriate thickness evenly underneath the 3 mounting screws.
11.11 Spreading vane replacement
Only your dealer or your specialist workshop may replace worn spreading vanes.
Requirement
• The spreading discs are removed (see 11.8.1 Dismounting the spreading discs).
• A spreading vane comprises a main vane and an extension vane.
• The main vane of the right-hand spreading disc has the designation BR and the corresponding
extension vane has the designation AR.
• The main vane of the left-hand spreading disc has the designation BL and the corresponding
extension vane has the designation AL.
Example: left-hand spreading disc
BL Main vane
AL Extension vane
Fig. 79: Spreading vane combination
11.11.1 Replacing the extension vane
n
Removing the extension vane
11. Maintenance and service
128
5902916 MDS 8.2/14.2/18.2/20.2