Implementation:
u
Loosen the hose fitting at the end of the hydraulic hose to be replaced.
u
Discharge the oil from the hydraulic hose.
u
Loosen the other end of the hydraulic hose.
u
Put the loose hose end into the oil collection tray immediately and plug the connection.
u
Loosen the hose fixtures and remove the hydraulic hose.
u
Connect the new hydraulic hose. Tighten the hose fittings.
u
Fix the hydraulic hose by means of the hose fixtures.
u
Check the position of the new hydraulic hose.
w
The hose routing must correspond to the one of the old hydraulic hose.
w
Friction points are to be excluded.
w
The hose may not be twisted or tensioned.
The hydraulic hoses have been replaced successfully.
11.13 Transmission oil
11.13.1 Quantities and types
The transmission is filled with approx. 2.2 l of SAE 90 API-GL-4 transmission oil.
Do not mix different types of oil.
• Never mix different oil types.
11.13.2 Checking the oil filling level
n
Oil level
For oil changes and dismounting the transmission, please contact your dealer or an authorized
specialist workshop.
The transmission does not need to be lubricated under normal operating conditions. However, we
recommend changing the oil after 10 years.
A shorter oil change interval is recommended if fertilizers with high dust content are used and the
spreader is frequently cleaned.
11. Maintenance and service
MDS 8.2/14.2/18.2/20.2 5902916
139
To Next Page
Loading...
