u
Remove the dirt deflector (refer to 3.10.1 Position of safety equipment as well as warning and
instruction stickers).
u
Fold up the protective grid in the hopper (refer to 11.3 Opening the protective grid in the hopper).
u
When cleaning with high-pressure, never aim the water jet directly at warning signs, electrical
equipment, hydraulic components, and sliding bearings.
u
Let the machine dry after cleaning.
Do not store the terminal outdoors. Store in a suitable warm location.
Lubricating the machine before winterization (refer to 13.3 Preserving the machine)
13.3 Preserving the machine
• Only spray on approved and environmentally friendly preserving agents.
• Prevent mineral oil-based agents (diesel, etc.). They are rinsed off when the machine is first
washed and can get into the sewage system.
• Only use preservation agents that will not attack the paint, plastics, and rubber seals.
u
Only spray the machine once certain that it is completely clean and dry.
u
Treat the machine with environmentally friendly anti-corrosion agents.
w
We recommend using protective wax or preservation wax.
Please contact your specialist dealer or your specialist workshop if you want to obtain preservation
agents.
Preserve the following assemblies or parts:
• All hydraulic components that are susceptible to rust, e.g., hydraulic couplers, pipes, press-fit
rings, and valves
• Galvanized bolts
• If present on your machine:
○ Parts of the braking system
○ Pneumatic lines
○ Spray galvanized bolts on the axles and the drawbar with a special protective wax after
washing.
13. Winterization and preservation
MDS 8.2/14.2/18.2/20.2 5902916
143
To Next Page
Loading...
