Rauch MDS 8.2 - Mounting the Transmission with Radial Pin Clutch

7.3.2 Mounting the transmission with radial pin clutch
ü
Check the mounting position. The drive shaft end that is marked with a tractor symbol must point
to the tractor.
u
Remove the protective cap.
Fig. 17: Loosening the universal drive shaft guard
u
Loosen the locking screw [1] of the drive shaft guard.
u
Turn the universal drive shaft guard to the demounting position.
u
Pull the universal drive shaft out.
7. Commissioning
46
5902916 MDS 8.2/14.2/18.2/20.2