WARNING!
Risk of injury due to incorrect procedure for setting the application rate
The stop lever is tensioned by a return spring. In the event of incorrect operation or failure to
observe the procedure for setting the application rate, the stop lever may unexpectedly move back
to the end of the guide slot.
This may result in injuries to the fingers or the face.
u
Never push against the spring pressure by hand to hold the stop lever in position during
volume setting.
u
Always observe the procedure for setting the application rate.
Setting the application rate
u
Close the metering slide.
Fig. 39: Scale for setting the application rate (driving direction right, versions K/D/C)
[1] Position indicator
[2] Setscrew
[3] Scale
[4] Stop
u
Loosen the setscrew [2] at the stop [4].
u
Determine the position for the scale setting in the fertilizer chart or based on the calibration test.
u
Set the stop [4] to the appropriate position.
u
Retighten the setscrew [2] at the stop.
n
Version Q
9. Spreading operation
74
5902916 MDS 8.2/14.2/18.2/20.2
To Next Page
Loading...
