Rauch MDS 8.2 - Page 95

Fig. 54: Setting the spreading width limiter
[1] Right closed metering slide
[2] Field-interior spreading disc (left here)
[3] Field border
[4] Track
[5] Adjustment nut
[A] Decrease the spreading width, left side
[B] Increase the spreading width, left side
u
Loosen the locking nut [5] on the adjustment piece.
u
For the position of the adjustment piece [3], refer to the table below.
u
Slide the adjustment piece to the determined value.
u
Tighten the locking nut [5].
For the zero position, place the two adjustment pieces on top of each other (congruent).
Adjustment
Limited spreading width from the center of the
track to the boundary (in meters)
Adjustment position
0.75 2 notches toward the spreading disc
1 1 notch toward the spreading disc
1.25 Zero position
1.5 1 notch away from the spreading disc
1.75 1.5 notches away from the spreading disc
2 2 notches away from the spreading disc
9. Spreading operation
MDS 8.2/14.2/18.2/20.2 5902916
95