CHAPTER
3
AccuFlow™ Vortex and AccuFlow™ HP+ Installation: 17
CHAPTER 3
ACCUFLOW™ VORTEX AND
ACCUFLOW™ HP+
INSTALLATION
The following sections are included to illustrate the proper procedure for mounting and plumbing the AccuFlow
system.
This section assumes that the Raven control console has already been installed and all installation and safety
procedures have been completed or understood.
NOTE: In addition to the Raven control console and associated cabling, a speed sensor and flow cabling
must also be installed with the Raven AccuFlow system. Refer to Testing the Speed Sensor Extension
Cable section on page 77 for examples of AccuFlow systems and cable connections. Contact a local
Raven dealer for more information and assistance.
When installing hoses, cables, and wires always take care that they cannot be pinched, cut, or otherwise damaged
during normal operation.
FIGURE 1. Typical Vortex System Single and Dual Valve
DANGER
Anhydrous ammonia can cause severe burning,
blindness, or death. Refer to Discharging the
AccuFlow™ System section on page 5 or page 61
and follow the procedure for bleeding the
AccuFlow system before beginning maintenance.
Primary Bleed
Valve
Secondary Bleed
Valve
Vapor Hose
Toolbar
Hose to
Breakaway
Bleed Circuit
Pressure Hose
Connection
Pressure
Gauge
Temperature Gauge
Vortex Cooler
Bleed Circuit Vapor
Hose Connection
Emergency Shut-Off
Valve
Manifold
Liquid
Applicator
Tube
Steel Vapor Tubes
Strainer/
Magnet
Assemblies
Check Valve
Assemblies
Flowmeter
Control or Fast Valve
On/Off Valve
(Not Used with
Fast Valve)
Bleed Line
To Next Page
Loading...
