CHAPTER 3
28 AccuFlow™ Vortex and AccuFlow™ HP+ Installation and Operation Manual
1. Slide a hose clamp over one end of the refrigerant line.
2. Slide the refrigerant line over the hose barb fitting.
3. Secure the hose clamp over the hose barb fitting.
4. Slide a hose clamp over the other end of the refrigerant line.
5. Slide the refrigerant line over the straight hose barb fitting.
6. Secure the hose clamp over the straight hose barb fitting.
MANIFOLD ASSEMBLY
There are variations in inlet manifolds. Locate the appropriate inlet manifold below and follow the appropriate
instructions to install your inlet manifold.
DUAL INLET MANIFOLD ASSEMBLY
FIGURE 15. Standard Inlet Manifold Assembly
FIGURE 16. Reverse Inlet Manifold Assembly
1. Apply PTFE thread sealant to all threaded joints.
2. Install the 2” pipe nipple into the end of the cooler.
Pipe Nipple
Check Valve
Strainer
Valve Assembly
Inlet Manifold
2” Pipe Nipple
Reducer
Bushing
1-1/2” Pipe
Nipple
Check Valve
Strainer
Valve Assembly
Inlet Manifold
2” Pipe Nipple
Reducer
Bushing
To Next Page
Loading...
Need help?
General
