CHAPTER 3
24 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
FIGURE 26. Upper Support Arm Installation
NOTE: 3/4XXX machines should use the narrowest set of mounting holes. If there is interference issues with
the catwalk, make adjustments to the catwalk.
2. Apply three drops of the supplied thread locking compound to the first few threads of each of the 5/8” -11 x 2”
bolts.
FIGURE 27. Bolt Assembly
3. Secure the upper support arm to the upper cross tubes using the provided 5/8” washers, 5/8” spacers, and 5/
8” bolts with the thread locking compound. Tighten the bolts to 130 ft-lbs.
Upper Support
Arm
(107-0172-335)
5/8” x 2” Bolts
(with thread
locking
compound),
Spacers, and
Washers
Upper Support Arm
(107-0172-335)
3/4XXX Mounting
Holes
Beveled Side
Towards Inside
Rear of Machine
Thread Locking
Compound (Three
Drops)
To Next Page
Loading...
