Installation: Installation 27
INSTALLATION
FIGURE 32. Stiffener Rod Installed
SAFETY DECAL PLATE AND REFLECTOR INSTALLATION
1. Secure the safety decal plate to the lower support using 5/8” - 11 x 2” bolts, 5/8” washers (two per bolt), and 5/
8” Nyloc nuts.
FIGURE 33. Safety Decal Plate Installed
2. Install the reflector decals on the safety decal plates. Place the orange decal above the red decal on each side
of the machine.
3. Tighten all previously installed 5/8” nyloc nuts to 150 ft-lbs.
Stiffener Rod
(107-0172-378)
Install Both Stiffener
Rods so Support Arm
is Closer to Inside of
Machine
To Next Page
Loading...
